How to use the Sound Meter
- Press Start and allow microphone access. The tool turns off echo cancellation, noise suppression and automatic gain control so the level is not altered.
- Hold the device still, with the microphone uncovered and pointing towards the sound.
- Read the live level, and watch minimum, maximum and average (Leq) build up. The chart shows the last 60 seconds.
- For better accuracy, put your device next to a calibrated sound level meter, enter its reading under Calibration and press Calibrate.
- Press Reset to start a fresh measurement, or Stop to release the microphone.
How accurate is a browser decibel meter?
Honest answer: it is an estimate. A real sound level meter has a calibrated microphone with a known sensitivity, so it can convert voltage to sound pressure. A web page cannot know how sensitive your laptop or phone microphone is, or how much gain the operating system applies. What the browser can measure precisely is the level of the digital signal relative to its maximum, in dBFS (decibels relative to full scale, where 0 dBFS is the loudest possible sample). This tool computes that level, then adds an offset to estimate dB SPL (sound pressure level).
The default offset of 100 dB is a rough starting point, not a measurement. Depending on the device, readings can be out by 10 dB or more. To improve them, place your device next to a calibrated meter (or a calibrator producing a known level), enter its reading and press Calibrate; the offset is then set so the two agree over the last two seconds. The offset is saved in your browser, and it remains valid only for the same device, microphone and input-volume setting.
Other limitations to know
- No frequency weighting. Professional meters usually report dB(A), which de-emphasises low and very high frequencies to mimic human hearing. This meter is unweighted, and phone microphones also roll off deep bass, so readings for rumbly noise can differ from dB(A).
- Limited range. Built-in microphones and their processing may compress or clip very loud sounds (often above 90–100 dB SPL), and very quiet rooms may sit at the device’s own noise floor.
- Processing. The tool requests a raw signal with echo cancellation, noise suppression and automatic gain control switched off. A few browsers or devices ignore this; if gain control stays on, you will see a warning.
For workplace noise assessments or legal disputes, use a Class 1 or Class 2 sound level meter (IEC 61672) operated by a qualified person.
What the numbers mean
Live level uses “fast” time weighting (a 125 ms exponential average, as defined in IEC 61672), so it follows speech and short sounds without flickering. Minimum and maximum are the lowest and highest fast-weighted values since you started or reset. Average (Leq) is the equivalent continuous level: the energy average over the whole measurement. Because decibels are logarithmic, Leq is dominated by the loud moments. One minute at 90 dB and nine minutes at 60 dB give an Leq of about 80 dB, not the 63 dB a simple average would suggest.
Typical sound levels
Approximate levels for common sounds, in line with figures published by the US Centers for Disease Control and Prevention (CDC) and the WHO. Real values depend on distance and the source.
| Level (dB) | Example |
|---|---|
| 10 | Normal breathing |
| 20 | Ticking watch |
| 30 | Soft whisper |
| 40 | Refrigerator hum, quiet library |
| 60 | Normal conversation, air conditioner |
| 70 | Washing machine, dishwasher |
| 80–85 | City traffic heard inside a car, petrol lawnmower, leaf blower |
| 95 | Motorcycle |
| 100 | Approaching subway train, car horn at 5 m, sporting events |
| 110 | Shouting or a dog barking right next to the ear |
| 120 | Standing near a siren |
| 140–150 | Firecrackers |
How much noise is safe? WHO guidance
The risk of noise-induced hearing loss depends on both level and time. The World Health Organization’s safe-listening guidance (the WHO–ITU H.870 standard for personal audio devices) uses a weekly sound allowance equivalent to 80 dB for 40 hours a week for adults, and 75 dB for 40 hours a week for children and sensitive listeners. Every 3 dB increase doubles the sound energy, so the safe time halves:
| Level | Weekly limit (WHO adult allowance) |
|---|---|
| 80 dB | 40 hours |
| 83 dB | 20 hours |
| 86 dB | 10 hours |
| 89 dB | 5 hours |
| 92 dB | 2.5 hours |
| 95 dB | About 75 minutes |
| 100 dB | About 24 minutes |
For workplaces, the US National Institute for Occupational Safety and Health (NIOSH) recommends a limit of 85 dB(A) averaged over 8 hours, also halving the time for every 3 dB. If you have to raise your voice to be heard by someone an arm’s length away, the noise is probably above 85 dB. Ringing in the ears (tinnitus) or muffled hearing after noise are warning signs. Use earplugs at concerts and with power tools, and turn personal audio down. To check a microphone before measuring, try the mic test.
Frequently asked questions
Is an online decibel meter accurate?
What is the difference between dBFS and dB SPL?
How loud is normal conversation in decibels?
What decibel level is dangerous?
Is my audio recorded?
Why does my reading differ from a sound level meter app?
Last reviewed November 2026. Results are estimates for information only — see our disclaimer.